File Name: what is cp and cpk .zip
In this paper the condition for the application of process capability indices is analyzed. On the basis of process capability indices, dynamic process capability indices as a new kind of indices to show the current process capability are discussed and the condition for the application of dynamic process capability indices is exhibited. Comparison between process capability index and dynamic process capability index and comparison between D p and D pk are made and the conclusions provide the approach for process control.
Histogram Cp Cpk Cheat Sheet. Knowledge Base Online User Guide. Cp is the capability index. It doesn't care if the process is centered within the limits only if it would fit if it was centered. Cpk is the centering capability index. It measures how well the data is centered between the spec limits.
This section is a brief overview of process capability and how process capability measurements can be incorporated into Genesys designs. The outputs of any process will vary and it is not uncommon that the performance of a circuit of system falls outside their specification limits. When a device falls outside its requirements in a manufacturing environment additional costs are accrued to either scrap or rework the product both of which increase manufacturing costs and reduce the ROI Return On Investment. Much can be done at the design level to maximize the production success rate. Statistical results are commonly used to determine product variation. The difference between the upper and lower specification is know as the tolerance. Capability indices have been developed to portray the relationship between specification limits and the design variation.
Cp, Pp, Cpk, and Ppk are capability and performance indicators for your process. Is a process capable? Is the process acceptable? How is the process actually behaving vs how it theoretically could be behaving? These are questions you can ask during a DMAIC project during both the measure phase if you have good, existing data or in the control phase after you have implemented your changes.
This article is not how to calculate Cpk or Ppk, as there are several resources in print or on the internet to figure that out. Instead this article is intended to explain the difference between the two and why the different calculations are important. In the short sense, Cpk and Ppk are about process capability and process performance, respectively. Process capability, Cpk, is important because it indicates whether a process potentially can meet a specification. Essentially, it is a prediction of the ability of a process to meet a specification.
•Cp: process capability index. •Cpk: minimum process capability index. •Pp: process performance index. •Ppk: minimum process performance index. •Definition: “ Process Capability is the measured, inherent variation of the product turned out.
Specification Specifications define product requirements. In other words, they define what is expected from an item for it to be usable. The upper specification limit USL is the upper limit of the specified range.
Note: The specifications must relate to customer requirements and customer expectations. This will involve a continuous communication with the customer. The Information you need, provided in an easy to understand visual format. Process Capability is a relatively simple statistical measure which provides an estimate on the level of process outputs which will be within permitted specification limits.
Действительно закончилось. Теперь можно возвращаться домой.
Было видно, что Хейл ей не поверил. - Может быть, хочешь воды. Она не нашлась что ответить. И проклинала. Как я могла не выключить монитор.
Гигантский компьютер содрогался мелкой дрожью, из густого клубящегося тумана падали капли воды. Сигналы тревоги гремели подобно грому. Коммандер посмотрел на вышедший из строя главный генератор, на котором лежал Фил Чатрукьян.
Колокола звонили где-то совсем рядом, очень громко. Беккер чувствовал жжение в боку, но кровотечение прекратилось.